The engine control unit and the transmission control unit are located inside the ECM. The engine control unit intercommunicates with the transmission control unit with the Controller Area Network (CAN).
If there is a problem in this intercommunication, the ECM stores a DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| U0100 | Lost Communication with ECM / PCM "A" | All conditions are met for 1.25 sec. (1-trip detection logic):
·
Ignition switch is ON ·
Battery voltage is 10.5 V or higher ·
No intercommunication between engine control unit and transmission control unit |
ECM | Comes on | DTC stored |
Perform registration and/or initialization when parts related to the automatic transaxle are replaced.
Click hereDrivetrain>U760E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>PRECAUTION
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Check if DTCs are output.
| Result | Proceed to |
|---|---|
| Only U0100 is output | A |
| U0100 and other DTCs are output | B |
A
B