Home › Engine / Hybrid System › 1AD-FTV STARTING › STARTER(w/ Stop And Start System) › 2013.11–2015.10
RM3090E _51 Engine / Hybrid System _008740 1AD-FTV STARTING _0103788 STARTER(w/ Stop And Start System) A

1AD-FTV STARTING  STARTER(w/ Stop And Start System)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly with the 2 bolts.

Torque:
64 N*m (653 kgf*cm, 47 ft.*lbf)


b.

Install the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Close the terminal cap.


d.

Connect the starter connector.


Hide 17361J 3.INSTALL NO. 1 AIR TUBE

a.

Install the No. 1 air tube with the 2 bolts.

Torque:
24 N*m (245 kgf*cm, 18 ft.*lbf)


b.

Tighten the 2 clamps.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)


c.

Attach the 2 wire harness clamps.


d.

Install the bolt and attach the wire harness clamp.

Torque:
7.7 N*m (79 kgf*cm, 68 in.*lbf)


Hide 5.CONNECT FUEL FILTER ASSEMBLY

a.

Connect the fuel filter assembly with the bolt.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


Hide 17801 8.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17705 9.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 74414B 10.INSTALL BATTERY BRACKET REINFORCEMENT

Hide 74411B 11.INSTALL FRONT BATTERY BRACKET

Hide 74431 12.INSTALL BATTERY TRAY

Hide 28800 13.INSTALL BATTERY

Hide 28899 14.INSTALL BATTERY INSULATOR

Hide 74404A 15.INSTALL BATTERY CLAMP SUB-ASSEMBLY

Hide 16.CONNECT CABLE TO POSITIVE BATTERY TERMINAL

Hide 51441 17.INSTALL NO. 1 ENGINE UNDER COVER

Hide 19.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION