Home › Engine / Hybrid System › 1AD-FTV STARTING › STARTER(w/o Stop And Start System) › 2013.11–2015.10
RM3090E _51 Engine / Hybrid System _008740 1AD-FTV STARTING _0103789 STARTER(w/o Stop And Start System) A

1AD-FTV STARTING  STARTER(w/o Stop And Start System)  INSTALLATION  


PROCEDURE

Hide 28100 1.INSTALL STARTER ASSEMBLY

a.

Install the starter assembly with the 2 bolts.

Torque:
64 N*m (653 kgf*cm, 47 ft.*lbf)


b.

Install the starter wire with the nut.

Torque:
9.8 N*m (100 kgf*cm, 87 in.*lbf)


c.

Close the terminal cap.


d.

Connect the starter connector.


Hide 17361J 3.INSTALL NO. 1 AIR TUBE

a.

Install the No. 1 air tube with the 2 bolts.

Torque:
24 N*m (245 kgf*cm, 18 ft.*lbf)


b.

Tighten the 2 clamps.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)


c.

Attach the 2 wire harness clamps.


d.

Install the bolt and attach the wire harness clamp.

Torque:
7.7 N*m (79 kgf*cm, 68 in.*lbf)


Hide 5.CONNECT FUEL FILTER ASSEMBLY

a.

Connect the fuel filter assembly with the bolt.

Torque:
7.0 N*m (71 kgf*cm, 62 in.*lbf)


Hide 17801 8.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

Hide 17705 9.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

Hide 74414B 10.INSTALL BATTERY BRACKET REINFORCEMENT

Hide 74431 12.INSTALL BATTERY TRAY

Hide 28800 13.INSTALL BATTERY

Hide 28899 14.INSTALL BATTERY INSULATOR

Hide 74404A 15.INSTALL BATTERY CLAMP SUB-ASSEMBLY

Hide 16.CONNECT CABLE TO POSITIVE BATTERY TERMINAL

Hide 51441 17.INSTALL NO. 1 ENGINE UNDER COVER

Hide 19.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION