Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SWITCH(for RHD) › 2013.11–2015.10
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0104315 LANE DEPARTURE ALERT SWITCH(for RHD) A

CRUISE CONTROL  LANE DEPARTURE ALERT SWITCH(for RHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 58901A 3.REMOVE REAR CONSOLE BOX SUB-ASSEMBLY

Hide 55433B 4.REMOVE LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

Hide 84978 5.REMOVE LANE-KEEPING ASSIST MAIN SWITCH (LANE DEPARTURE ALERT SWITCH)

a.
B357146

Detach the 2 claws and remove the lane-keeping assist main switch (lane departure alert switch).