Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SWITCH(for RHD) › 2013.11–2015.10
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0104315 LANE DEPARTURE ALERT SWITCH(for RHD) A

CRUISE CONTROL  LANE DEPARTURE ALERT SWITCH(for RHD)  INSTALLATION  


PROCEDURE

Hide 84978 1.INSTALL LANE-KEEPING ASSIST MAIN SWITCH (LANE DEPARTURE ALERT SWITCH)

a.

Attach the 2 claws to install the lane-keeping assist main switch (lane departure alert switch).


Hide 55433B 2.INSTALL LOWER NO. 2 INSTRUMENT PANEL FINISH PANEL

Hide 58901A 3.INSTALL REAR CONSOLE BOX SUB-ASSEMBLY

Hide 4.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION