Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT BUZZER(for RHD) › 2013.11–2015.10
RM3090E _51 Engine / Hybrid System _008749 CRUISE CONTROL _0104317 LANE DEPARTURE ALERT BUZZER(for RHD) A

CRUISE CONTROL  LANE DEPARTURE ALERT BUZZER(for RHD)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55950G 4.REMOVE DEFROSTER NOZZLE ASSEMBLY

Hide 55870B 5.REMOVE HEATER TO REGISTER DUCT ASSEMBLY

Hide 86652A 6.REMOVE SKID CONTROL BUZZER ASSEMBLY (LANE DEPARTURE ALERT BUZZER)

B357148

a.

Detach the clamp.


b.

Disconnect the connector and remove the skid control buzzer assembly (lane departure alert buzzer).