This DTC is stored if the television camera assembly receives a signal via CAN communication from the spiral with sensor cable sub-assembly that indicates an internal malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1626 | Steering Angle Sensor Failure | A fail flag is transmitted from the spiral with sensor cable sub-assembly. | ·
Spiral with sensor cable sub-assembly ·
Television camera assembly |
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.
Replace the spiral with sensor cable sub-assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE(for Single Type)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
Check for DTCs.
| Proceed to |
|---|
| DTC C1626 is not output |
| DTC C1626 is output |
DTC C1626 is not output
DTC C1626 is output