Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU) › from 2013.11
RM3090E _56 Audio / Visual / Telematics _008432 PARK ASSIST / MONITORING _0103549 PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU) C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU)  C1691  Back Camera Initialization Incomplete  


DESCRIPTION

This DTC is stored when the television camera assembly judges that the back camera initial setting has not been memorized (back camera position setting is incomplete).

DTC No. Detection Item DTC Detection Condition Trouble Area
C1691 Back Camera Initialization Incomplete Back camera initial setting has not been memorized (back camera position setting is incomplete)
·

Back camera position setting

·

Television camera assembly



CAUTION / NOTICE / HINT

NOTICE:

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU)>CALIBRATION


PROCEDURE

1.ADJUST SETTINGS (BACK CAMERA POSITION SETTING)
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the television camera assembly.



Result:
Proceed to
NEXT



NEXT

2.CHECK DTC
2.CHECK DTC
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU)>DTC CHECK / CLEAR

Chassis > IPA/Parking Assist Monitor > Clear DTCs
50002 85

b.

Check for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU)>DTC CHECK / CLEAR

Chassis > IPA/Parking Assist Monitor > Trouble Codes
50001 85
HINT:
·

If DTC C1691 is output, perform the back camera position setting again.

·

If DTC C1691 is still output after performing the back camera position setting 3 times, replace the television camera assembly.




Result:
Proceed to
DTC C1691 is not output
DTC C1691 is output.



DTC C1691 is not output

END

DTC C1691 is output.