Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU) › from 2013.11
RM3090E _56 Audio / Visual / Telematics _008432 PARK ASSIST / MONITORING _0103549 PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU) C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU)  U0073  Control Module Communication Bus "A" Off  U0126  Lost Communication with Steering Angle Sensor Module  U0140  Lost Communication with Body Control Module  U0163  Lost Communication with Navigation Control Module  


DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the television camera assembly.

HINT:

If CAN communication system DTCs are stored, they may also be stored in other systems.


DTC No. Detection Item DTC Detection Condition Trouble Area
U0073 Control Module Communication Bus "A" Off Lost communication with bus off CAN communication system
U0126 Lost Communication with Steering Angle Sensor Module Lost communication with spiral with sensor cable sub-assembly CAN communication system
U0140 Lost Communication with Body Control Module Lost communication with main body ECU (multiplex network body ECU) CAN communication system
U0163 Lost Communication with Navigation Control Module Lost communication with spiral with navigation receiver assembly (for navigation receiver type) or radio and display receiver assembly (for radio and display type) CAN communication system

PROCEDURE

1.CHECK DTC
a.

b.

Check for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(for Camera built-in ECU)>DATA LIST / ACTIVE TEST

Chassis > IPA/Parking Assist Monitor > Trouble Codes
50001 85
HINT:
·

If CAN communication system DTCs are stored, they may also be stored in other systems.

·

If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.

·

If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.

for LHD:

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM

for RHD:

Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for RHD)>DIAGNOSIS SYSTEM




Result:
Proceed to
No DTCs are output
DTCs are output (for LHD)
DTCs are output (for RHD)



No DTCs are output

DTCs are output (for LHD)

DTCs are output (for RHD)