This circuit sends a signal to the stereo component amplifier assembly to mute noise. Because of that, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short in the circuit, even though the stereo component amplifier assembly is functioning normally, no sound or only an extremely faint sound can be heard.
Remove the stereo component amplifier assembly with its connector still connected.
Click hereAudio / Visual / Telematics>AUDIO / VIDEO>STEREO COMPONENT AMPLIFIER>REMOVAL
| *a | Component with harness connected
(Stereo Component Amplifier Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| M32-1 (MUTE) - Body ground | Ignition switch ACC, audio system playing
→ Changing modes |
3.5 V or higher
→ Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G143 radio and display receiver assembly connector.
Disconnect the M32 stereo component amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G143-16 (MUT1) - M32-1 (MUTE) | Always | Below 1 Ω |
| G143-16 (MUT1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the radio and display receiver assembly connector.
| *a | Front view of wire harness connector
(to Radio and Display Receiver Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| G143-16 (MUT1) - Body ground | Ignition switch ACC, audio system playing→ Changing modes | Above 3.5 V→ Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG