These DTCs are stored if there is a malfunction in the CAN communication system connected to the multimedia module receiver assembly.
If CAN communication system DTCs are stored, they may also be stored in other systems.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U0126 | Steering Sensor Communication | Lost communication with spiral with sensor cable sub-assembly | CAN communication system |
| U0129 | VSC(ECB)ECU Communication | Lost communication with brake actuator assembly (skid control ECU) | CAN communication system |
| U0140 | Lost Communication with Body Control Module | Lost communication with main body ECU (multiplex network body ECU) | CAN communication system |
Clear the DTCs.
Check for DTCs.
No DTCs are output.
If CAN communication system DTCs are stored, they may also be stored in other systems.
If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs (Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM(for LHD)>DIAGNOSIS SYSTEM).
| Proceed to |
|---|
| No DTCs are output |
| DTCs are output |
No DTCs are output
DTCs are output