Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type) › 2013.11–2014.10
RM3090E _56 Audio / Visual / Telematics _008432 PARK ASSIST / MONITORING _0103548 PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type) J

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type)  Guide Lines are Displayed with Vehicle Center Line  


DESCRIPTION

The television camera assembly can create parking guide lines. Since this function is not necessary on vehicles with the parking assist monitor system, the guide line creation function of the television camera assembly is disabled.

WIRING DIAGRAM

E224386E03
3.323,1.104 5.167,1.344 1.844,0.24 10 Television Camera Assembly 2.625,0.292 2.802,0.479 0.177,0.188 10 1 2.813,0.406 3.313,0.594 0.5,0.188 10 CURT 3.313,0.927 3.813,1.115 0.5,0.188 10 U6

CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point (Click here Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type)>INITIALIZATION).

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here Audio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM(for Navigation Receiver Type)>CALIBRATION).



PROCEDURE

1.CHECK SCREEN MODE
a.
E226200E01
2.499,0.326 2.825,0.531 0.326,0.206 10 *a 1.782,1.267 2.467,0.432 2.467,0.432 1.832,1.492 false 2.467,0.432 1.89,1.643 false

Check the back guide monitor screen.


Result:
Result Proceed to
Guide lines are displayed with vehicle center line. A
Guide lines are displayed without vehicle center line. B



A

2.CHECK HARNESS AND CONNECTOR (TELEVISION CAMERA ASSEMBLY - BODY GROUND)

B

2.CHECK HARNESS AND CONNECTOR (TELEVISION CAMERA ASSEMBLY - BODY GROUND)
a.

Disconnect the U6 television camera assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
U6-1 (CURT) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR