Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › from 2013.11
RM3090E _56 Audio / Visual / Telematics _008775 AUDIO / VIDEO _0048748 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  CD cannot be Inserted / Played or CD is Ejected Right After Insertion  


PROCEDURE

1.CHECK IF A PROPER CD IS INSERTED
a.

Make sure that the CD is an audio CD or a CD with an MP3, WMA or ACC file, and that it is not deformed, flawed, stained, deteriorated or otherwise defective.

HINT:
·

Translucent or uniquely-shaped CDs cannot be played.

·

CDs with adhesive paper labels should not be played.

·

Commercial audio CDs can be played.

·

CD-DA files on CD-ROMs, CD-Rs and CD-RWs can be played.

·

MP3, WMA and ACC files on CD-ROMs, CD-Rs and CD-RWs can be played.

·

For details on playable CDs, refer to the Owner's Manual.




Result:
Proceed to
CD is normal
CD is not normal



CD is normal

2.CHECK THAT CD IS INSERTED PROPERLY

CD is not normal

END (CD IS DEFECTIVE)

2.CHECK THAT CD IS INSERTED PROPERLY
a.

Check whether or not the CD is inserted upside down.


Result:
Proceed to
CD is properly inserted
CD is not properly inserted



CD is properly inserted

3.CLEAN CD AND RECHECK

CD is not properly inserted

SET CD PROPERLY

3.CLEAN CD AND RECHECK
a.
I100151

Disc cleaning

i.

If dirt is on the disc surface, wipe it clean with a soft cloth from the inside to the outside in a radial direction.

NOTICE:

Do not use a conventional record cleaner or antistatic preservative.




Result:
Proceed to
Malfunction disappears
Malfunction appears



Malfunction disappears

END (CD IS DIRTY)

Malfunction appears

4.CHECK CD
4.CHECK CD
a.

Replace the CD with a known good one and check that the malfunction disappears.


Result:
Proceed to
Malfunction disappears
Malfunction appears



Malfunction disappears

END (CD IS DEFECTIVE)

Malfunction appears

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY