Home › Engine / Hybrid System › 2AD-FHV FUEL › FUEL TEMPERATURE SENSOR
RM3090E _51 Engine / Hybrid System _008734 2AD-FHV FUEL _0106052 FUEL TEMPERATURE SENSOR A

2AD-FHV FUEL  FUEL TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89454 1.INSTALL FUEL TEMPERATURE SENSOR

NOTICE:

If the fuel temperature sensor is dropped, replace it with a new one.


a.

Apply a light coat of engine oil to a new O-ring.


b.

Install the O-ring to the fuel temperature sensor.


c.

Temporarily install the fuel temperature sensor to the fuel supply pump assembly.


d.
A316156C01
2.26,2.01 2.844,2.448 false 1.51,2.958 1.823,3.156 0.313,0.198 10 false *a 2.896,2.385 3.354,2.583 0.458,0.198 10 false SST
*a Fulcrum length


Using SST, tighten the fuel temperature sensor.

SST
09922-10010  

NOTICE:

Use the formula to calculate special torque values for situations where a SST is combined with a torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Torque:
without SST : 22 N*m (224 kgf*cm, 16 ft.*lbf)
with SST : 12.5 N*m (127 kgf*cm, 9 ft.*lbf)


Hide 22100 2.INSTALL FUEL SUPPLY PUMP ASSEMBLY

Hide 3.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION