Home › Engine / Hybrid System › 2AD-FTV FUEL › FUEL TEMPERATURE SENSOR
RM3090E _51 Engine / Hybrid System _008735 2AD-FTV FUEL _0106053 FUEL TEMPERATURE SENSOR A

2AD-FTV FUEL  FUEL TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

NOTICE:
·

When replacing the injector assemblies (including shuffling the injector assemblies between the cylinders), common rail assembly, intake manifold or cylinder head sub-assembly, it is necessary to replace the injection pipes with new ones.

·

When replacing the fuel supply pump assembly, common rail assembly, intake manifold or cylinder head sub-assembly, it is necessary to replace the fuel inlet pipe sub-assembly with a new one.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 22100 3.REMOVE FUEL SUPPLY PUMP ASSEMBLY

Hide 89454 4.REMOVE FUEL TEMPERATURE SENSOR

NOTICE:
·

Before replacing the fuel temperature sensor, be sure to clean the surrounding area.

·

When replacing the fuel temperature sensor, make sure that your hands are clean and do not use gloves, etc.

·

If the fuel temperature sensor is dropped, replace it with a new one.



a.
A311938

Using SST, remove the fuel temperature sensor.

SST
09922-10010  


b.
A311939

Remove the O-ring from the fuel temperature sensor.