Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for HDD) › 2013.11–2014.10
RM3090E _56 Audio / Visual / Telematics _008776 NAVIGATION / MULTI INFO DISPLAY _0048745 NAVIGATION SYSTEM(for HDD) Y

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for HDD)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the navigation system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
·

When troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.

·

Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

·

The following 5 items are important points in problem analysis:

What Vehicle model, system name
When Date, time, occurrence frequency
Where Road conditions
Under what conditions? Driving conditions, weather conditions
How did it happen? Problem symptoms


Result:
Proceed to
NEXT



NEXT

3.INSPECT BATTERY VOLTAGE
3.INSPECT BATTERY VOLTAGE
a.

Measure the battery voltage.

Standard voltage:

11 to 14 V


HINT:

If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.



Result:
Proceed to
NEXT



NEXT

4.CHECK CABIN
4.CHECK CABIN
a.

Check that condensation is not likely to occur in the cabin, and that the temperature is not high or extremely low in the cabin.

OK:

Condensation is not likely being produced and the temperature is not high or extremely low.


HINT:
·

A humid cabin and a rapid change in temperature may lead to condensation. Condensation in the cabin may cause a short circuit.

·

The navigation system may not operate normally when the temperature is -20°C (-4°F) or lower, or 65°C (149°F) or higher.




Result:
Proceed to
OK
NG



OK

5.CHECK NAVIGATION SYSTEM NORMAL CONDITION

NG

SET CABIN TO APPROPRIATE TEMPERATURE

5.CHECK NAVIGATION SYSTEM NORMAL CONDITION

Result:
Proceed to
Symptom is not normal operation
Symptom is normal operation



Symptom is not normal operation

6.CHECK CAN COMMUNICATION SYSTEM*

Symptom is normal operation

SYMPTOM IS NORMAL OPERATION

6.CHECK CAN COMMUNICATION SYSTEM*

Result:
Proceed to
CAN DTCs are not output
CAN DTCs are output



CAN DTCs are not output

7.CHECK FOR DTC*

CAN DTCs are output

7.CHECK FOR DTC*
a.

Refer to DTC Check/Clear.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for HDD)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Proceed to
DTCs are output
DTCs are not output



DTCs are output

8.DTC CLEAR*

DTCs are not output

11.CHECK HARD DISC
8.DTC CLEAR*
a.

Refer to DTC Check/Clear.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for HDD)>DTC CHECK / CLEAR

HINT:

The present DTCs may not indicate actual malfunctions depending on the vehicle operating conditions.


Body Electrical > Navigation System > Clear DTCs
50002 212

Result:
Proceed to
NEXT



NEXT

9.RECHECK FOR DTC*
9.RECHECK FOR DTC*
a.

Refer to DTC Check/Clear.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for HDD)>DTC CHECK / CLEAR

HINT:
·

Even if the malfunction symptom is not confirmed, check for DTCs. This is because the system stores history DTCs.

·

If more information is needed, perform a recheck using the "System Check Mode" screen after rechecking for DTCs using the GTS.

·

Check the DTCs and inspect the area that the code indicates.



Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Proceed to
DTCs are output
DTCs are not output



DTCs are output

10.DIAGNOSTIC TROUBLE CODE CHART

DTCs are not output

11.CHECK HARD DISC
10.DIAGNOSTIC TROUBLE CODE CHART

Result:
Proceed to
NEXT



NEXT

14.CHECK CIRCUIT
11.CHECK HARD DISC
a.

Enter the "HDD Check" screen. Refer to Check Hard Disc in Operation Check.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for HDD)>OPERATION CHECK

OK:

"OK" is displayed.



Result:
Proceed to
OK
NG



OK

12.PROBLEM SYMPTOMS TABLE

NG

12.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for HDD)>PROBLEM SYMPTOMS TABLE

HINT:

If the symptom does not recur and no DTCs are output, attempt to reproduce the symptoms.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING



Result:
Proceed to
Fault is not listed in Problem Symptoms Table
Fault is listed in Problem Symptoms Table



Fault is not listed in Problem Symptoms Table

13.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM

Fault is listed in Problem Symptoms Table

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE

13.PERFORM TROUBLESHOOTING BASED ON MALFUNCTION SYMPTOM

NEXT

14.CHECK CIRCUIT
14.CHECK CIRCUIT
a.

Adjust, repair or replace as necessary.


Result:
Proceed to
NEXT



NEXT

15.RECHECK FOR DTC*
15.RECHECK FOR DTC*
a.

After clearing DTCs, recheck for DTCs.

Click hereAudio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for HDD)>DTC CHECK / CLEAR

Body Electrical > Navigation System > Trouble Codes
50001 212

Result:
Proceed to
NEXT



NEXT

16.PERFORM CONFIRMATION TEST
16.PERFORM CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END