These DTCs are stored when a malfunction occurs in the navigation ECU sub-assembly.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15A0 | LAN Master Malfunction | When either condition below is met:
·
Bus malfunction ·
EEPROM error |
Navigation ECU sub-assembly |
| B15AD | Navigation Processor Malfunction | When one of the conditions below is met:
·
A short to ground, short to +B or open occurs in the gyro signal circuit ·
Gyro sensor malfunction ·
GPS receiver malfunction |
Navigation ECU sub-assembly |
| B15B0 | Display Screen Malfunction | Picture circuit (TFT unit) malfunction | Navigation ECU sub-assembly |
| B15B3 | Radio Tuner Malfunction | When one of the conditions below is met:
·
AM tuner PLL is unlocked ·
FM tuner PLL is unlocked ·
Tuner malfunction |
Navigation ECU sub-assembly |
| B15B5 | DVD Changer Malfunction | When one of the conditions below is met:
·
Mechanical communication error ·
Read malfunction ·
Mechanical malfunction |
Navigation ECU sub-assembly |
| B15B7 | Bluetooth Module Malfunction | "Bluetooth" module malfunction | Navigation ECU sub-assembly |
Clear the DTCs.
Recheck for DTCs and check if the same DTC is output again.
| Proceed to |
|---|
| No DTCs are output |
| DTCs are output |
No DTCs are output
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
DTCs are output