Home › Engine / Hybrid System › 2AR-FE FUEL › FUEL TANK(w/ Canister Pump Module) › from 2014.10
RM3090E _51 Engine / Hybrid System _008397 2AR-FE FUEL _0056278 FUEL TANK(w/ Canister Pump Module) A

2AR-FE FUEL  FUEL TANK(w/ Canister Pump Module)  REMOVAL  


PROCEDURE

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 4.DRAIN FUEL

Hide 5.DISCONNECT PARKING BRAKE CABLE

a.
A293546

Remove the 2 bolts and disconnect the parking brake cable.


Hide 50819 6.REMOVE FRONT FLOOR COVER

a.
A332503

Remove the bolt and nut.


b.

Detach the 5 clips and remove the front floor cover.


Hide 58398F 8.REMOVE NO. 1 FLOOR UNDER COVER

a.
A271432

Detach the clip and remove the 2 nuts and No. 1 floor under cover.


Hide 77209D 9.DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

a.
A299329

Disconnect the fuel tank main tube sub-assembly from the fuel pipe.

Click hereEngine / Hybrid System>2AR-FE FUEL>FUEL SYSTEM(w/ Canister Pump Module)>PRECAUTION


Hide 77019J 10.DISCONNECT FUEL TANK TO CANISTER TUBE SUB-ASSEMBLY

a.
A299330

Disconnect the fuel tank to canister tube sub-assembly.

Click hereEngine / Hybrid System>2AR-FE FUEL>FUEL SYSTEM(w/ Canister Pump Module)>PRECAUTION


Hide 77276 11.REMOVE FUEL HOSE PROTECTOR

A195897

a.

Detach the claw and remove the fuel hose protector from the fuel tank to filler pipe hose.


Hide 77213E 12.DISCONNECT FUEL TANK TO FILLER PIPE HOSE

a.
A195898

Loosen the hose clamp and disconnect the fuel tank to filler pipe hose from the fuel tank.


Hide 77404 13.DISCONNECT FUEL TANK VENT HOSE SUB-ASSEMBLY

a.
A300565

Detach the hose clamp and fuel tank vent hose sub-assembly.


Hide 77202 14.DISCONNECT BREATHER TUBE SUB-ASSEMBLY

a.
A299331

Disconnect the breather tube sub-assembly from the fuel tank filler pipe.

Click hereEngine / Hybrid System>2AR-FE FUEL>FUEL SYSTEM(w/ Canister Pump Module)>PRECAUTION


Hide 77100 15.REMOVE FUEL TANK ASSEMBLY

a.
A299332

Disconnect the connector and detach the 3 wire harness clamps.


b.

Using an engine lifter and attachments, support the fuel tank assembly.


c.
A293555

Remove the 2 bolts and No. 1 fuel tank band sub-assembly.


d.

Remove the 2 bolts and No. 1 fuel tank band sub-assembly LH.


e.

Remove the 2 bolts and No. 2 fuel tank band sub-assembly.


f.

Slightly lower the engine lifter.

NOTICE:

Be careful not to cut the wiring.



g.
A299333

Disconnect the fuel pump connector and sender gauge connector.

NOTICE:
·

Before this procedure, check the connector for dirt, mud or other contamination.

·

Do not use any tools in this procedure.




h.

Detach the wire harness from the 3 clamps and remove the fuel tank assembly.


Hide 77209D 16.DISCONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY

Hide 77168A 17.REMOVE FUEL TANK VENT TUBE SET PLATE

Hide 18.REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP

Hide 83320 19.REMOVE FUEL SENDER GAUGE ASSEMBLY

Hide 77209D 20.REMOVE FUEL TANK MAIN TUBE SUB-ASSEMBLY

A299337C01
1.25,0.76 0.917,0.417 0.917,0.417 0.833,0.417 false 0.417,2.49 0.417,2.333 0.417,2.333 0.333,2.333 false 1,1.906 0.833,1.75 0.833,1.75 0.75,1.75 false 1.573,1.458 1.417,1.333 1.417,1.333 1.333,1.333 false 2,1.167 1.833,1 1.833,1 1.75,1 false 2.646,0.885 2.5,0.667 2.5,0.667 2.417,0.667 false 0.667,0.313 0.979,0.469 0.313,0.156 10 *1 2.25,0.563 2.563,0.719 0.313,0.156 10 *2 1.167,1.229 1.479,1.385 0.313,0.156 10 *3 0.167,2.229 0.479,2.385 0.313,0.156 10 *4 0.583,1.646 0.896,1.802 0.313,0.156 10 *4 1.583,0.896 1.896,1.052 0.313,0.156 10 *4
*1 Fuel Tank Main Tube Sub-assembly
*2 No. 3 Fuel Tube Clamp
*3 No. 5 Fuel Tube Clamp
*4 Fuel Tube Grommet


a.

Detach the 5 clamps and remove the fuel tank main tube sub-assembly.


Hide 77289B 21.REMOVE NO. 3 FUEL TUBE CLAMP

a.

Remove the No. 3 fuel tube clamp from the fuel tank assembly.


Hide 77299A 22.REMOVE NO. 5 FUEL TUBE CLAMP

a.

Remove the No. 5 fuel tube clamp from the fuel tank assembly.


Hide 77295D 23.REMOVE FUEL TUBE GROMMET

a.

Remove the 3 fuel tube grommets from the fuel tank assembly.


Hide 77202 24.REMOVE BREATHER TUBE SUB-ASSEMBLY

a.
A299334

Disconnect the quick connector and remove the breather tube sub-assembly from the fuel tank assembly.

Click hereEngine / Hybrid System>2AR-FE FUEL>FUEL SYSTEM(w/ Canister Pump Module)>PRECAUTION


Hide 77643A 25.REMOVE NO. 3 FUEL TANK PROTECTOR

a.
A299335

Remove the No. 3 fuel tank protector from the fuel tank assembly.