Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION ECU › 2014.10–2015.10
RM3090E _56 Audio / Visual / Telematics _008776 NAVIGATION / MULTI INFO DISPLAY _0148145 NAVIGATION ECU A

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 86140A 3.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY (for Radio and Display Type)

Hide 4.REMOVE WIRE HARNESS

E306826

a.

Disconnect each connector and remove the wire harness.


Hide 86211 5.REMOVE NO. 1 RADIO BRACKET

E306830

a.

Remove the 5 screws and No. 1 radio bracket.


Hide 86212 6.REMOVE NO. 2 RADIO BRACKET

E306831

a.

Remove the 5 screws and No. 2 radio bracket.


Hide 86841 7.REMOVE NAVIGATION ECU

a.
E306827

Detach the 2 guides and remove the navigation ECU as shown in the illustration.


b.
E306828

Detach the clamp.


c.

Disconnect the connector and remove the antenna cord.