This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the navigation system vehicle customization screen.
The certification ECU (smart key ECU assembly) controls the entry and start system (for Entry Function) related items that are customizable via the radio and display receiver assembly screen.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15F7 | Certification ECU Vehicle Information Reading/Writing Process Malfunction | Certification ECU (smart key ECU assembly) vehicle setting processing error. | ·
CAN communication system ·
Entry and start system (for Entry Function) ·
Certification ECU (smart key ECU assembly) ·
Radio and display receiver assembly |
Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Use the GTS to check if the CAN communication system is functioning normally.
for LHD:
for RHD:
CAN communication DTCs are not output.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for LHD) | B |
| NG (for RHD) | C |
A
B
C
Check if the entry and start system (for Entry Function) is malfunctioning.
Customization may not be possible depending on the malfunction in the entry and start system (for Entry Function).
No malfunctions are present in the entry and start system (for Entry Function).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Display the "Vehicle Customization" screen.
Make a note of the customizable items for each certification ECU (smart key ECU assembly) related system.
These items shown as customizable via the navigation system vehicle customization screen can also be changed manually. In a following step, a manual procedure will be used.
Check the customize parameters list for the entry and start system (for Entry Function) related items that can be customized via the radio and display receiver assembly screen.
Manually change and confirm that it was possible to successfully change the settings of the customize parameters for each system that are available for customization via the radio and display receiver assembly screen.
The items available for customization via the radio and display receiver assembly screen can be customized successfully using the manual procedure.
| Proceed to |
|---|
| OK |
| NG |
OK
NG