Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for Radio and Display Type) › 2014.10–2015.10
RM3090E _56 Audio / Visual / Telematics _008776 NAVIGATION / MULTI INFO DISPLAY _0148247 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  Vehicle Speed Signal Circuit between Radio Receiver and Extension Module  


DESCRIPTION

The navigation ECU receives a vehicle speed signal from the radio and display receiver assembly and information from the navigation antenna assembly, and then adjusts vehicle position.

WIRING DIAGRAM

E292618E02
1.208,1.063 1.823,1.26 0.615,0.198 10 false SPDO 1.729,0.948 2.344,1.146 0.615,0.198 10 false 2 0.688,1.979 1.302,2.177 0.615,0.198 10 false Y1 0.698,2.135 2.417,2.479 1.719,0.344 10 false Radio and Display Receiver Assembly 2.875,1.729 4.333,1.958 1.458,0.229 10 false No. 1 Navigation Wire 5.333,0.948 5.948,1.146 0.615,0.198 10 false 5 5.542,1.094 6.156,1.292 0.615,0.198 10 false SPD 5.438,2.146 6.656,2.354 1.219,0.208 10 false Navigation ECU 5.438,2 6.052,2.198 0.615,0.198 10 false Y5

CAUTION / NOTICE / HINT

NOTICE:

Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING


PROCEDURE

1.CHECK NO. 1 NAVIGATION WIRE (RADIO AND DISPLAY RECEIVER ASSEMBLY - NAVIGATION ECU)
a.

Disconnect the Y1 radio and display receiver assembly connector.


b.

Disconnect the Y5 navigation ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Y1-2 (SPDO) - Y5-5 (SPD) Always Below 1 Ω
Y1-2 (SPDO) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG