Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM(for Radio and Display Type) › 2014.10–2015.10
RM3090E _56 Audio / Visual / Telematics _008776 NAVIGATION / MULTI INFO DISPLAY _0148247 NAVIGATION SYSTEM(for Radio and Display Type) J

NAVIGATION / MULTI INFO DISPLAY  NAVIGATION SYSTEM(for Radio and Display Type)  Parking Brake Switch Circuit  


DESCRIPTION

This circuit includes the parking brake switch assembly and radio and display receiver assembly.

WIRING DIAGRAM

E280960E05
3.948,1.521 4.104,1.719 0.156,0.198 10 false 1 5.229,1.49 5.448,1.688 0.219,0.198 10 false 15 5.51,1.635 6.052,1.854 0.542,0.219 10 false PKB 5.208,2.677 5.75,2.896 0.542,0.219 10 false G143 5.208,2.833 6.885,3.177 1.677,0.344 10 false Radio and Display Receiver Assembly 2.885,2.188 4.25,2.542 1.365,0.354 10 false Parking Brake Switch Assembly 2.865,2 3.406,2.219 0.542,0.219 10 false G37

CAUTION / NOTICE / HINT

NOTICE:

Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.

Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING


PROCEDURE

1.CHECK VEHICLE SIGNAL (OPERATION CHECK)

b.

Check that the display changes between ON and OFF according to the parking brake operation.

OK:
Parking Brake Condition Display
Applied ON
Released OFF


HINT:

This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.



Result:
Proceed to
OK
NG



OK

NG

2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - PARKING BRAKE SWITCH ASSEMBLY)
a.

Disconnect the G143 radio and display receiver assembly connector.


b.

Disconnect the G37 parking brake switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
G143-15 (PKB) - G37-1 Always Below 1 Ω
G143-15 (PKB) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

3.INSPECT PARKING BRAKE SWITCH ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.INSPECT PARKING BRAKE SWITCH ASSEMBLY
a.

Remove the parking brake switch assembly.

Click hereBrake>PARKING BRAKE>PARKING BRAKE SWITCH>REMOVAL


b.

Inspect the parking brake switch assembly.

Click hereBrake>PARKING BRAKE>PARKING BRAKE SWITCH>INSPECTION


Result:
Proceed to
OK
NG



OK

NG

REPLACE PARKING BRAKE SWITCH ASSEMBLY