Home › Drivetrain › K111 MULTIDRIVE / CVT › OIL PRESSURE SENSOR › from 2014.10
RM3090E _52 Drivetrain _008435 K111 MULTIDRIVE / CVT _0047075 OIL PRESSURE SENSOR A

K111 MULTIDRIVE / CVT  OIL PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89637K 1.INSTALL OIL PRESSURE SENSOR

a.

Coat the O-ring of the pressure sensor with Toyota Genuine CVT fluid FE.


b.
C279991C02
2.448,0.813 2.448,0.552 2.448,0.552 2.677,0.552 false 0.885,0.344 1.833,0.156 1.833,0.156 2.458,0.146 false 2.729,0.469 3.25,0.698 0.521,0.229 10 SST 2.625,1.656 2.938,1.917 0.313,0.26 10 *a 0.396,1.219 0.75,1.5 0.354,0.281 10 *b 2.51,0.083 3.042,0.323 0.531,0.24 10 SST
*a Length of SST 50 mm (1.97 in.)
*b Length of Torque Wrench 180 mm (7.09 in.)


Using SST, install the oil pressure sensor.

SST
09326-22011  

Torque:
without SST : 21 N*m (214 kgf*cm, 15 ft.*lbf)
with SST : 16 N*m (163 kgf*cm, 12 ft.*lbf)

NOTICE:
·

This torque value is effective when SST is parallel to the torque wrench.

·

The "with SST" torque value is effective when using SST with a fulcrum lengthof 50 mm (1.97 in.).

·

The "with SST" torque value is effective when using a torque wrench with a fulcrum length of 180 mm (7.09 in.).

·

If using a torque wrench with a different length, or connecting the torque wrench and SST at an angle, refer to the alternate torque values.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION




c.

Connect the oil pressure sensor connector.


Hide 51444A 2.INSTALL REAR ENGINE UNDER COVER LH