Home › Engine / Hybrid System › 3ZR-FAE ENGINE MECHANICAL › DRIVE BELT › from 2015.04
RM3090E _51 Engine / Hybrid System _008387 3ZR-FAE ENGINE MECHANICAL _0046810 DRIVE BELT A

3ZR-FAE ENGINE MECHANICAL  DRIVE BELT  REMOVAL  


PROCEDURE

Hide 11212 1.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 51443 2.REMOVE REAR ENGINE UNDER COVER RH

a.
A292527

Remove the 4 clips and rear engine under cover RH.


Hide 16361A 3.REMOVE V-RIBBED BELT

a.
A313142C02
2.083,1.427 2.25,1.427 2.25,1.427 2.583,1.094 true 2.031,2.75 2.333,1.833 2.333,1.833 2.5,1.833 true 0.833,3.667 1,3.667 1,3.667 1.76,2.906 true 0.656,1.208 1.188,0.615 1.188,0.615 1.479,0.615 true 0.552,0.906 1.01,0.406 1.01,0.406 1.229,0.406 true 1.854,1.333 2.063,1.51 0.208,0.177 10 true *a 2.542,1.75 2.698,1.948 0.156,0.198 10 false A 0.698,3.583 0.854,3.781 0.156,0.198 10 false B 1.26,0.313 1.469,0.49 0.208,0.177 10 true *c 1.51,0.521 1.719,0.698 0.208,0.177 10 true *b
*a 5 mm Bi-hexagon Wrench
*b Hole
*c Gap


Attach a wrench to the hexagonal portion (A) or (B) of the V-ribbed belt tensioner assembly as shown in the illustration.


b.

Rotate the V-ribbed belt tensioner assembly clockwise to align the hole with the gap, and then insert a 5 mm bi-hexagon wrench into the hole and gap to secure the V-ribbed belt tensioner assembly.


c.

Remove the V-ribbed belt from the V-ribbed belt tensioner assembly.