Home › Drivetrain › K111F MULTIDRIVE / CVT › CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM › from 2015.04
RM3090E _52 Drivetrain _009408 K111F MULTIDRIVE / CVT _0051011 CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM C

K111F MULTIDRIVE / CVT  CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM  P2769  Short in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL)  P2770  Open in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL)  


DESCRIPTION

The ECM turns shift solenoid valve SL on or off to control the oil pressure applied to the lock-up relay valve and turns lock-up on or off.

DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P2769 Short in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL) 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
1.

Lock-up is operating.

2.

There is a short circuit in the shift solenoid valve SL circuit.

3.

Detected 2 times or more consecutively

4.

1 trip detection logic


·

Short in shift solenoid valve SL circuit

·

Continuously variable transaxle assembly

·

ECM


Comes on DTC stored
P2770 Open in Torque Converter Clutch Solenoid Circuit (Shift Solenoid Valve SL) 1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
1.

Lock-up is operating.

2.

There is an open circuit in the shift solenoid valve SL circuit.

3.

Detected 2 times or more consecutively

4.

1 trip detection logic


·

Open in shift solenoid valve SL circuit

·

Continuously variable transaxle assembly

·

ECM


Comes on DTC stored

MONITOR DESCRIPTION

These DTCs indicate an open or short circuit in the shift solenoid valve SL circuit. When there is an open or short circuit in the shift solenoid valve SL circuit, the ECM detects the problem, illuminates the MIL and stores the DTC.

WIRING DIAGRAM

C251558E10
5.802,3.031 6.167,3.229 0.365,0.198 10 B75 5.792,3.229 6.188,3.458 0.396,0.229 10 ECM 0.167,2.771 0.531,2.969 0.365,0.198 10 B37 0.146,2.969 4.208,3.208 4.063,0.24 10 Transmission Wire (Continuously Variable Transaxle Assembly) 5.615,1.25 6.021,1.458 0.406,0.208 10 SL 5.323,1.375 5.594,1.594 0.271,0.219 10 68 3.635,1.375 3.844,1.573 0.208,0.198 10 2 3.26,1.125 3.667,1.354 0.406,0.229 10 SL 1.521,1.74 3.323,1.979 1.802,0.24 10 Shift Solenoid Valve SL

CAUTION / NOTICE / HINT

NOTICE:
·

Perform initialization when parts related to the continuously variable transaxle are replaced.

Click hereDrivetrain>K111F MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>INITIALIZATION

·

Check that no DTCs are stored after performing initialization.

Click hereDrivetrain>K111F MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM>DTC CHECK / CLEAR



PROCEDURE

1.INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SL)
a.
C199169C08
1.906,0.948 2.458,0.469 true 2.552,0.375 2.99,0.615 0.438,0.24 10 SL 0.115,0.094 0.427,0.292 0.313,0.198 10 *a
*a Component without harness connected
(Transmission Wire)


Disconnect the transmission wire connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 (SL) - Body ground 20°C (68°F) 11 to 15 Ω



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM)

NG

4.REPLACE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY
2.CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM)
a.
C267934C17
1.49,0.135 1.938,0.385 0.448,0.25 0.563,1.781 0.854,1.01 true 1.604,0.177 2.063,0.375 0.458,0.198 10 B75 0.302,1.854 1.021,2.104 0.719,0.25 10 68 (SL) 0.115,0.083 0.385,0.323 0.271,0.24 10 *a
*a Front view of wire harness connector
(to ECM)


Disconnect the ECM connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
B75-68 (SL) - Body ground 20°C (68°F) 11 to 15 Ω



Result:
Proceed to
OK
NG



OK

3.REPLACE ECM

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

3.REPLACE ECM

Result:
Proceed to
NEXT



NEXT

4.REPLACE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY
a.

Replace the continuously variable transaxle assembly.

Click hereDrivetrain>K111F MULTIDRIVE / CVT>CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY>REMOVAL


Result:
Proceed to
NEXT



NEXT