Home › Power Source / Network › 3ZR-FAE BATTERY / CHARGING › BATTERY CURRENT SENSOR › from 2015.04
RM3090E _57 Power Source / Network _008394 3ZR-FAE BATTERY / CHARGING _0049599 BATTERY CURRENT SENSOR A

3ZR-FAE BATTERY / CHARGING  BATTERY CURRENT SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 28850 2.REMOVE BATTERY STATE SENSOR ASSEMBLY (BATTERY STATE SENSOR ASSEMBLY WITH NEGATIVE BATTERY TERMINAL)

a.
A348601

Remove nut and disconnect the No. 3 engine wire from the battery state sensor assembly.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



b.

Disconnect the connector from the battery state sensor assembly.


c.

Loosen the nut and remove the battery state sensor assembly from the battery.


d.
A348602

Detach the 2 claws and remove the battery state sensor assembly from the battery current sensor holder.