Home › Power Source / Network › 3ZR-FAE BATTERY / CHARGING › BATTERY CURRENT SENSOR › from 2015.04
RM3090E _57 Power Source / Network _008394 3ZR-FAE BATTERY / CHARGING _0049599 BATTERY CURRENT SENSOR A

3ZR-FAE BATTERY / CHARGING  BATTERY CURRENT SENSOR  INSTALLATION  


PROCEDURE

Hide 28850 1.INSTALL BATTERY STATE SENSOR ASSEMBLY (BATTERY STATE SENSOR ASSEMBLY WITH NEGATIVE BATTERY TERMINAL)

a.
A348603N01
0.719,0.354 0.875,0.552 0.156,0.198 10 false 2 2.135,0.948 2.292,1.146 0.156,0.198 10 false 1

Set the battery state sensor assembly onto the battery current sensor holder, and the attach the 2 claws to install it.


b.
A348604N01
2.417,1.938 2.708,2.135 0.292,0.198 10 false 10° 2.042,1.938 2.333,2.135 0.292,0.198 10 false 10°

Install the battery state sensor assembly to the battery and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

Position the battery state sensor assembly as shown in the illustration.



c.

Connect the No. 3 engine wire to the battery state sensor assembly with nut.

Torque:
7.6 N*m (77 kgf*cm, 67 in.*lbf)


d.

Connect the connector to the battery state sensor assembly.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION