Home › Drivetrain › K114F MULTIDRIVE / CVT › TRANSMISSION CONTROL CABLE › from 2015.04
RM3090E _52 Drivetrain _036009 K114F MULTIDRIVE / CVT _0172319 TRANSMISSION CONTROL CABLE N

K114F MULTIDRIVE / CVT  TRANSMISSION CONTROL CABLE  ADJUSTMENT  


PROCEDURE

Hide 1.INSPECT SHIFT LEVER POSITION

a.

While moving the shift lever from N to each position, check that the lever moves smoothly and that the shift position indicator comes on properly according to the shift lever position.


b.

Turn the ignition switch to ON state and check the following:

i.

When the shift lever is moved to D, the vehicle moves forward.


ii.

When the shift lever is moved to R, the vehicle moves in reverse.

NOTICE:

The vehicle should not move when the shift position indicator is off.




Hide 58910C 2.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 3.ADJUST SHIFT LEVER POSITION

a.

Move the shift lever to N.


b.
C328343C01
1.073,0.292 1.365,0.292 1.365,0.292 1.75,1.021 true 2.292,1.125 2.51,1.417 2.51,1.417 2.76,1.417 true 2.26,2.083 2.26,1.813 2.26,1.813 2.646,1.813 false 1.177,1.854 1.708,1.854 1.708,1.854 1.823,2.219 false 0.885,0.198 1.198,0.396 0.313,0.198 10 false *1 2.844,1.333 3.156,1.531 0.313,0.198 10 false *2 2.719,1.719 3.031,1.917 0.313,0.198 10 false *2 0.99,1.76 1.302,1.958 0.313,0.198 10 false *1
*1 Slider
*2 Lock Piece
V113147

Slide in this Direction
V113148

Pull in this Direction


Slide the slider of the transmission control cable assembly in the direction indicated by the arrow and pull the lock piece outward.


c.
C328344C01
0.188,0.646 0.188,0.156 0.188,0.156 0.969,0.156 true 1.135,0.583 1.396,0.333 1.396,0.333 3.01,0.333 true 0.656,0.875 0.906,1.25 0.906,1.25 1.177,1.25 true 1.021,0.073 1.333,0.271 0.313,0.198 10 true *1 3.073,0.24 3.385,0.438 0.313,0.198 10 false *2 1.25,1.167 1.563,1.365 0.313,0.198 10 false *3
*1 Cable Rod
*2 Adjuster Case
*3 Lock Piece
V113147

Push in this Direction


Gently lift the cable rod with your fingers to pull the cable tight.


d.

Push the lock piece into the adjuster case.

NOTICE:
·

Check that the shift lever position sensor and the shift lever are in neutral.

·

Securely push in the lock piece until the slider lock is engaged.




e.

After adjusting the shift lever position, check the operation and function of the shift lever. If there is a problem, adjust the position again.


Hide 58910C 4.INSTALL REAR CONSOLE BOX ASSEMBLY