Home › Vehicle Interior › HEATING / AIR CONDITIONING › COMPRESSOR(for 2WW) › 2015.10–2016.08
RM3090E _58 Vehicle Interior _008789 HEATING / AIR CONDITIONING _0208269 COMPRESSOR(for 2WW) A

HEATING / AIR CONDITIONING  COMPRESSOR(for 2WW)  REMOVAL  


PROCEDURE

Hide 1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM

Hide 16400 2.REMOVE RADIATOR ASSEMBLY

Hide 88704 4.DISCONNECT SUCTION HOSE SUB-ASSEMBLY

a.
E332763

Remove the bolt and disconnect the suction hose sub-assembly.


b.

Remove the O-ring from the suction hose sub-assembly.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



Hide 88703 5.DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY

a.
E332764

Remove the bolt and disconnect the discharge hose sub-assembly.


b.

Remove the O-ring from the discharge hose sub-assembly.

NOTICE:

Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.



Hide 88310 6.REMOVE COMPRESSOR ASSEMBLY WITH PULLEY

a.
E332765

Disconnect the connector.


b.

Detach the clamp and disconnect the wire harness.


c.

Remove the bolt and 2 nuts.


d.
E332766

Using an E8 "TORX" socket wrench, remove the 2 stud bolts and compressor assembly with pulley.


e.

Remove the compressor pin.

NOTICE:

It is not necessary to remove a compressor pin unless it being replaced.