Home › Engine / Hybrid System › 2WW ENGINE CONTROL › DIESEL THROTTLE BODY › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208481 DIESEL THROTTLE BODY A

2WW ENGINE CONTROL  DIESEL THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 22030 1.INSTALL DIESEL THROTTLE BODY ASSEMBLY

a.

Connect the diesel throttle body assembly connector.


b.

Install a new gasket to the air tube assembly.


c.

Attach the 2 claws to install the air tube assembly to the diesel throttle body assembly.


d.

Using an E8 "TORX" socket wrench, install a new gasket and the diesel throttle body assembly with air tube assembly to the intake manifold with the 3 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

NOTICE:

Avoid physical shock to the diesel throttle body assembly.



e.

Using a T27 "TORX" socket wrench, install the air tube assembly to the cylinder block sub-assembly with the bolt.

HINT:

Refer to "SPECIFICATIONS - STANDARD BOLT" for the tightening torque.



f.

Attach the clamp and connect the No. 7 engine wire connector.


g.

Connect the intake air temperature sensor connector.


h.

Attach the 2 wire harness clamps.


i.

Connect the water by-pass hose assembly and radiator hose sub-assembly to the air tube assembly.


Hide 17343D 2.INSTALL NO. 3 AIR HOSE

a.

Install the No. 3 air hose to the air tube assembly and tighten the hose clamp.


Hide 3.INSTALL WIRE HARNESS CLAMP BRACKET

a.

Install the wire harness clamp bracket with the bolt.

HINT:

Refer to "SPECIFICATIONS - STANDARD BOLT" for the tightening torque.



b.

Using a T27 "TORX" socket wrench, install the 2 bolts.

HINT:

Refer to "SPECIFICATIONS - STANDARD BOLT" for the tightening torque.



c.
A349789

Attach the 2 clamps.


Hide 16400 4.INSTALL RADIATOR ASSEMBLY