Home › Engine / Hybrid System › 2WW ENGINE CONTROL › MASS AIR FLOW METER › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208484 MASS AIR FLOW METER A

2WW ENGINE CONTROL  MASS AIR FLOW METER  INSTALLATION  


PROCEDURE

Hide 22204 1.INSTALL MASS AIR FLOW METER SUB-ASSEMBLY

HINT:

Perform "Air Flow Meter Learning Value Reset" after replacing the mass air flow meter sub-assembly.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>INITIALIZATION


a.

Using a T20 "TORX" socket wrench, install the mass air flow meter sub-assembly to the air cleaner cap sub-assembly with the 2 screws.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)

NOTICE:

Avoid physical shock to the mass air flow meter sub-assembly.



b.

Connect the mass air flow meter sub-assembly connector.


Hide 2.PERFORM INITIALIZATION

a.

Perform "Air Flow Meter Learning Value Reset" after replacing the mass air flow meter sub-assembly.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>INITIALIZATION