Home › Engine / Hybrid System › 2WW ENGINE CONTROL › CRANKSHAFT POSITION SENSOR › from 2015.10
RM3090E _51 Engine / Hybrid System _044372 2WW ENGINE CONTROL _0208486 CRANKSHAFT POSITION SENSOR A

2WW ENGINE CONTROL  CRANKSHAFT POSITION SENSOR  REMOVAL  


PROCEDURE

Hide 17410 1.REMOVE FRONT EXHAUST PIPE ASSEMBLY

Hide 2.REMOVE CRANKSHAFT POSITION SENSOR

a.
A315741

Using a T25 "TORX" socket wrench, remove the bolt.


b.

Disconnect the crankshaft position sensor connector and remove the crankshaft position sensor.

NOTICE:

Avoid physical shock to the crankshaft position sensor.