The engine stop and start ECU detects open/close of the engine hood based on a signal received from the engine hood courtesy switch that is built into the hood lock assembly.
The engine stop and start ECU prohibits starting of the engine by stop and start control and stalls the engine if the clutch pedal is depressed with the engine hood open while the engine is stopped by stop and start control.
The engine stop and start ECU permits starting of the engine by stop and start control if the engine hood is opened with the clutch pedal depressed while the engine is stopped by stop and start control.
Before performing this step, check that the engine hood can be opened by pulling the hood lock control cable.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Stop and Start / Data List / Hood Courtesy Switch.
| Tester Display |
|---|
| Hood Courtesy Switch |
Read the value displayed on the GTS when the engine hood is opened and closed.
| Tester Display | Condition | Normal Condition |
|---|---|---|
| Hood Courtesy Switch | Engine hood is closed | ON |
| Engine hood is open | OFF |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 2WW)>PROBLEM SYMPTOMS TABLE
NG
Inspect the engine hood courtesy switch (hood lock assembly).
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENGINE HOOD COURTESY SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the A50 engine hood courtesy switch (hood lock assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A50-1 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the A66 engine stop and start ECU connector.
Disconnect the A50 engine hood courtesy switch (hood lock assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A66-7 (BNT1) - A50-2 (+) | Always | Below 1 Ω |
| A66-7 (BNT1) - Body ground | Always | 10 kΩ or higher |
| A50-2 (+) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 2WW)>PROBLEM SYMPTOMS TABLE
NG