Stop and start control can be disabled by pressing the stop and start system cancel switch (combination switch assembly). The stop and start system cancel switch (combination switch assembly) is a momentary-type switch that switches between on and off when the switch is pressed. While stop and start control is disabled, the stop and start cancel indicator light is illuminated to inform the driver.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Stop and Start / Data List / Cancel Switch.
Read the value when the stop and start system cancel switch (combination switch assembly) is pressed.
| Tester Display |
|---|
| Cancel Switch |
| Tester Display | Condition | Normal Condition |
|---|---|---|
| Cancel Switch | Stop and start system cancel switch (combination switch assembly) is pressed | ON |
| Stop and start system cancel switch (combination switch assembly) is not pressed | OFF |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 2WW)>PROBLEM SYMPTOMS TABLE
NG
Inspect the stop and start system cancel switch (combination switch assembly)
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM CANCEL SWITCH ASSEMBLY>REMOVAL
Disconnect the G70 stop and start system cancel switch (combination switch assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G70-4 (E) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G87 engine stop and start ECU connector.
Disconnect the G70 stop and start system cancel switch (combination switch assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G87-5 (ECAN) - G70-2 (ECU) | Always | Below 1 Ω |
| G87-5 (ECAN) - Body ground | Always | 10 kΩ or higher |
| G70-2 (ECU) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 2WW)>PROBLEM SYMPTOMS TABLE
NG