Home › Power Source / Network › 3ZR-FE BATTERY / CHARGING › GENERATOR(for 130 A Type) › from 2015.10
RM3090E _57 Power Source / Network _008412 3ZR-FE BATTERY / CHARGING _0208765 GENERATOR(for 130 A Type) A

3ZR-FE BATTERY / CHARGING  GENERATOR(for 130 A Type)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 51441 3.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51443 4.REMOVE REAR ENGINE UNDER COVER RH

Hide 11212 5.REMOVE NO. 2 CYLINDER HEAD COVER

Hide 27020 7.REMOVE GENERATOR ASSEMBLY

a.
A293795

Remove the terminal cap.


b.

Remove the nut and disconnect the wire harness from terminal B.


c.

Disconnect the connector and detach the wire harness clamp.


d.
A296608

Remove the 2 bolts and adjusting bar.


e.
A296609

Remove the bolt and generator.


f.
A285298

Remove the bolt and wire harness clamp bracket.