*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage.
11 to 14 V (Ignition switch off)
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
If the battery voltage is below 11 V, recharge or replace the battery and initialize* the integrated current value using the GTS.
*: Use the GTS to perform Integrated Current Value Initialization.
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 2WW)>REGISTRATION
If the Data List item "Integrated Current" is 0 or higher, it is not necessary to perform initialization.
Check the fuses and relays.
Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 2WW)>DTC CHECK / CLEAR
Check for freeze frame data.
Record or print DTCs and freeze frame data if necessary.
Clear the DTCs and freeze frame data.
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 2WW)>DTC CHECK / CLEAR
Recheck for DTCs.
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 2WW)>DTC CHECK / CLEAR
If any DTCs for the CAN communication system are output, troubleshoot those DTCs first.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| DTC is output | B |
A
B
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 2WW)>DIAGNOSTIC TROUBLE CODE CHART
Refer to Problem Symptoms Table.
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 2WW)>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Data List / Active Test
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 2WW)>DATA LIST / ACTIVE TEST
Terminals of ECU
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 2WW)>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Warm up the engine.
Turn the air conditioning system off.
Drive the vehicle for 5 to 40 minutes.
Stop the vehicle, move the shift lever to neutral and release the clutch pedal. Check if the engine is stopped by the stop and start control.
If the engine is not stopped by stop and start control, air fuel ratio learning and idle speed learning are necessary. Allow the engine to idle for 3 minutes and check that the engine speed is within 50 rpm of the target idle speed.
Depress the clutch pedal and check that the engine restarts.
| Proceed to |
|---|
| NEXT |
NEXT