Home › Engine / Hybrid System › 2WW EMISSION CONTROL › EGR VALVE › from 2015.10
RM3090E _51 Engine / Hybrid System _044375 2WW EMISSION CONTROL _0210861 EGR VALVE A

2WW EMISSION CONTROL  EGR VALVE  INSTALLATION  


PROCEDURE

Hide 25620 1.INSTALL EGR VALVE ASSEMBLY

a.
A350709

Install a new gasket to the EGR cooler assembly as shown in the illustration.


b.

Using a T30H "TORX" socket wrench, install the EGR valve assembly with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


c.

Install 2 new EGR cooler hoses to the EGR cooler assembly and EGR valve assembly.


d.

Hold SST and tighten the SST bolt as shown in the illustration.

A350715C01
1.219,1.365 1.323,1.365 1.323,1.365 1.375,1.594 false 4.615,1.542 4.688,1.542 4.688,1.542 4.813,1.781 true 0.896,1.281 1.229,1.469 0.333,0.188 10 false SST 1.927,1.271 2.125,1.479 0.198,0.208 10 true *b 1.031,1.76 1.25,1.979 0.219,0.219 10 true *a 4.302,1.458 4.635,1.646 0.333,0.188 10 false SST 5.635,2.51 5.865,2.698 0.229,0.188 10 true *b 5.24,1.438 5.427,1.646 0.188,0.208 10 true *a
*a Hold *b Turn


SST
09521-24010  

NOTICE:

Do not damage the EGR cooler hose.



e.

Remove SST from the EGR cooler hose clamp.


f.

Install the grommet to the EGR cooler assembly


Hide 25680 2.INSTALL EGR COOLER ASSEMBLY WITH EGR VALVE ASSEMBLY