Home › Engine / Hybrid System › 2WW EMISSION CONTROL › EXHAUST GAS TEMPERATURE SENSOR(for Sensor 1) › from 2015.10
RM3090E _51 Engine / Hybrid System _044375 2WW EMISSION CONTROL _0210865 EXHAUST GAS TEMPERATURE SENSOR(for Sensor 1) A

2WW EMISSION CONTROL  EXHAUST GAS TEMPERATURE SENSOR(for Sensor 1)  REMOVAL  


PROCEDURE

Hide 12611 1.REMOVE NO. 1 ENGINE COVER

Hide 2.DISCONNECT VACUUM CONTROL VALVE BRACKET

a.
A341650

Disconnect the exhaust gas temperature sensor connector


b.

Detach the wire harness clamp.


c.
A341651C01
0.688,0.271 0.854,0.219 0.854,0.219 0.969,0.219 true 0.604,1.604 0.719,1.604 0.719,1.604 0.813,2.198 true 2.583,2.083 2.917,2.25 2.917,2.25 3.01,2.25 true 0.385,1.5 0.615,1.719 0.229,0.219 10 true *a 0.99,0.115 1.188,0.302 0.198,0.188 10 false *c 3.052,2.167 3.302,2.406 0.25,0.24 10 true *b
*a Air Fuel Ratio Sensor Connector
*b Exhaust Gas Temperature Sensor Connector
*c Clamp


Disconnect the exhaust gas temperature sensor connector.


d.

Disconnect the air fuel ratio sensor connector.


e.

Raise the air fuel ratio sensor connector from the vacuum control valve bracket.


f.

Move the clamp as shown in the illustration, and disconnect the air fuel ratio sensor and exhaust gas temperature sensor.

NOTICE:

Disconnect the sensors while opening the clamp.



g.

Detach the air fuel ratio sensor clamp from the vacuum control valve bracket.


h.
A341652

Using a T20 "TORX" socket wrench, remove the 3 screws and disconnect the vacuum control valve bracket.


Hide 17271 3.REMOVE NO. 1 TURBO INSULATOR

a.
A341653

Remove the 3 bolts, nut and No. 1 turbo insulator.


Hide 89425 4.REMOVE EXHAUST GAS TEMPERATURE SENSOR (for Sensor 1)

NOTICE:

If the exhaust gas temperature sensor is dropped, replace it with a new one.


a.
A341654

Using a 14 mm union nut wrench, remove the exhaust gas temperature sensor.