Home › Engine / Hybrid System › 2WW EMISSION CONTROL › EXHAUST GAS TEMPERATURE SENSOR(for Sensor 2) › from 2015.10
RM3090E _51 Engine / Hybrid System _044375 2WW EMISSION CONTROL _0210866 EXHAUST GAS TEMPERATURE SENSOR(for Sensor 2) A

2WW EMISSION CONTROL  EXHAUST GAS TEMPERATURE SENSOR(for Sensor 2)  REMOVAL  


PROCEDURE

Hide 12611 1.REMOVE NO. 1 ENGINE COVER

Hide 89425 2.REMOVE EXHAUST GAS TEMPERATURE SENSOR (for Sensor 2)

NOTICE:

If the exhaust gas temperature sensor is dropped, replace it with a new one.


a.
A341658

Disconnect the exhaust gas temperature sensor connector.


b.

Detach the wire harness clamp.


c.

Disconnect the wire harness from the hook on the cylinder head cover side.


d.

Using a 14 mm union nut wrench, remove the exhaust gas temperature sensor.