Home › Engine / Hybrid System › 2WW EMISSION CONTROL › EXHAUST GAS TEMPERATURE SENSOR(for Sensor 2) › from 2015.10
RM3090E _51 Engine / Hybrid System _044375 2WW EMISSION CONTROL _0210866 EXHAUST GAS TEMPERATURE SENSOR(for Sensor 2) A

2WW EMISSION CONTROL  EXHAUST GAS TEMPERATURE SENSOR(for Sensor 2)  INSTALLATION  


PROCEDURE

Hide 89425 1.INSTALL EXHAUST GAS TEMPERATURE SENSOR (for Sensor 2)

a.
A359364C01
2.573,1.677 2.802,1.896 0.229,0.219 10 true *a
*a Torque Wrench Fulcrum Length


Using a 14 mm union nut wrench, install the exhaust gas temperature sensor.

Torque:
Specified tightening torque : 30 N*m (306 kgf*cm, 22 ft.*lbf)

NOTICE:

If the exhaust gas temperature sensor is dropped, replace it with a new one.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using a 14 mm union nut wrench (fulcrum length of 25 mm (0.984 in.)) + torque wrench (fulcrum length of 300 mm (11.8 in.)): 28 N*m (286 kgf*cm, 21 ft.*lbf)




b.

Pass the wire harness through the hook on the cylinder head cover side.


c.

Attach the wire harness clamp.


d.

Connect the exhaust gas temperature sensor connector.