Home › Engine / Hybrid System › 2WW EMISSION CONTROL › DIFFERENTIAL PRESSURE SENSOR › from 2015.10
RM3090E _51 Engine / Hybrid System _044375 2WW EMISSION CONTROL _0210869 DIFFERENTIAL PRESSURE SENSOR G

2WW EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89481B 1.CHECK DIFFERENTIAL PRESSURE SENSOR

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / Adaptation Value of Differential Pressure at Particle Filter.

Powertrain > Engine and ECT > Data List
Tester Display
Adaptation Value of Differential Pressure at Particle Filter
50003 371 116

e.

Disconnect the No. 1 vacuum transmitting hose from the differential pressure sensor.


f.
A341660C01
0.405,2.675 0.735,2.838 0.330,0.163 10 SST 0.792,2.763 0.962,2.763 0.962,2.763 1.174,3.062 false
V100135

Pressure


Using SST, apply pressure to the differential pressure sensor.

SST
09992-00242  


g.

Check the pressure value of the differential pressure sensor.

Standard Pressure:

Approximately the same pressure as the applied pressure is indicated on the GTS.


NOTICE:

Perform the inspection within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).


If the result is not as specified, check the differential pressure sensor circuit.

Click hereEngine / Hybrid System>2WW ENGINE CONTROL>ECD SYSTEM>P2454


h.

Connect the No. 1 vacuum transmitting hose to the differential pressure sensor.