Home › Engine / Hybrid System › 2WW ENGINE MECHANICAL › DRIVE BELT › from 2015.10
RM3090E _51 Engine / Hybrid System _044373 2WW ENGINE MECHANICAL _0211283 DRIVE BELT A

2WW ENGINE MECHANICAL  DRIVE BELT  INSTALLATION  


PROCEDURE

Hide 16361A 1.INSTALL FAN AND GENERATOR V BELT

a.

Rotate the pulley of the V-ribbed belt tensioner assembly clockwise, and then install the fan and generator V belt.

NOTICE:

Make sure that the fan and generator V belt is set properly on each pulley.



Hide 2.INSTALL REAR ENGINE UNDER COVER RH

a.

Install the rear engine under cover RH with the 2 clips.


Hide 3.INSTALL NO. 1 ENGINE UNDER COVER