Home › Engine / Hybrid System › 2WW ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL › from 2015.10
RM3090E _51 Engine / Hybrid System _044373 2WW ENGINE MECHANICAL _0211286 FRONT CRANKSHAFT OIL SEAL A

2WW ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 16361A 1.REMOVE V-RIBBED BELT

Hide 13471 2.REMOVE CRANKSHAFT PULLEY

a.
A315445

Remove the plug from the cylinder block.


b.
A318549E01
2,1.833 2.583,1.833 true 2.656,1.74 3.198,1.969 0.542,0.229 10 true SST (A)

Set SST (A) to the plug hole of the cylinder block.

SST (A):

PZ4TB-04951-26



c.
A318548C01
0.667,0.667 0.917,0.667 0.917,0.667 1.375,1.083 true 2,4.25 2.333,4.25 true 0.521,2.896 0.583,2.667 0.583,2.667 0.667,2.667 true 0.104,0.594 0.635,0.917 0.531,0.323 10 false SST (B) 2.396,4.177 2.927,4.5 0.531,0.323 10 true SST (A) 0.698,2.583 0.917,2.75 0.219,0.167 10 true *a
*a Groove


Using SST (B), turn the crankshaft pulley clockwise until SST (A) fits into the groove of the flywheel with damper assembly.

SST (B):

PZ4TB-04933-80



d.

Using SST (A), hold the flywheel with damper assembly.


e.
A315448

Using an E10 "TORX" socket wrench, remove the 4 bolts and crankshaft pulley.


Hide 11301C 3.REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL

a.
A315449C01
1.167,1.854 1.167,1.229 true 1.094,1.885 1.406,2.083 0.313,0.198 10 false *a
*a Protective Tape


Using a screwdriver, pry out the timing gear case or timing chain case oil seal.

NOTICE:

Do not damage the oil seal press fit hole, crankshaft or the surface of the timing gear case or timing chain case.


HINT:

Tape the screwdriver tip before use.