Home › Engine / Hybrid System › 2WW ENGINE MECHANICAL › FRONT CRANKSHAFT OIL SEAL › from 2015.10
RM3090E _51 Engine / Hybrid System _044373 2WW ENGINE MECHANICAL _0211286 FRONT CRANKSHAFT OIL SEAL A

2WW ENGINE MECHANICAL  FRONT CRANKSHAFT OIL SEAL  INSTALLATION  


PROCEDURE

Hide 11301C 1.INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL

a.
A315450E01
0.583,1.698 0.833,1.698 0.833,1.698 1.083,1.198 false 0.042,1.604 0.979,2 0.938,0.396 10 false SST (A)

Using an 8 mm hexagon wrench, install SST (A) to the crankshaft.

SST:

PZ4TB-04961-27



b.

Set a new timing gear case or timing chain case oil seal to the cylinder block.


c.
A315451E01
0.75,1.688 0.917,1.688 0.917,1.688 1.083,1.271 false 0.198,1.604 1.115,2.104 0.917,0.5 10 false SST (B)

Install SST (B) to SST (A).

SST:

PZ4TB-04961-27



d.
A315452E01
0.583,1.833 0.583,1.667 0.583,1.667 0.75,1.25 false 0.365,1.896 0.927,2.115 0.563,0.219 10 false SST (C)

Install and tighten SST (C) to install the timing gear case or timing chain case oil seal to the crankshaft.

SST:

PZ4TB-04961-27


HINT:

Tighten SST (C) until SST (B) contacts the cylinder block.



e.

Remove SST (C), SST (B) and SST (A).


Hide 13471 2.INSTALL CRANKSHAFT PULLEY

a.
A315447E01
2,1.833 2.5,1.833 true 2.542,1.75 2.969,1.969 0.427,0.219 10 true SST

Using SST, hold the flywheel sub-assembly.

SST:

PZ4TB-04951-26



b.

Install the crankshaft pulley to the crankshaft with 4 new bolts.

HINT:

The crankshaft pulley bolts are tightened in 2 progressive steps.



c.

Step 1:

i.

Using an E10 "TORX" socket wrench, tighten the 4 bolts.

Torque:
: 40 N*m (408 kgf*cm, 30 ft.*lbf)



d.

Step 2:

i.

Mark the RH side of each crankshaft pulley bolt with paint.


ii.

Tighten the bolts 120°.


iii.

Check that the paint marks are now at a 120° angle to the RH side.



e.

Remove SST.


f.

Install the plug to the cylinder block.