Home › Drivetrain › K111F MULTIDRIVE / CVT › OIL PAN › from 2015.10
RM3090E _52 Drivetrain _009408 K111F MULTIDRIVE / CVT _0051012 OIL PAN A

K111F MULTIDRIVE / CVT  OIL PAN  REMOVAL  


PROCEDURE

Hide 51441 1.REMOVE NO. 1 ENGINE UNDER COVER

Hide 51444 2.REMOVE REAR ENGINE UNDER COVER LH

Hide 51218A 3.REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT LH

Hide 35125 4.REMOVE NO. 1 TRANSMISSION OIL FILLER TUBE

a.
C279061

Using a 6 mm socket hexagon wrench, remove the overflow plug and gasket from the continuously variable transaxle assembly.


b.
C279062C04
2.583,0.823 2.833,0.396 2.833,0.396 2.948,0.396 false 2.99,0.323 3.302,0.521 0.313,0.198 10 *1
*1 No. 1 Transmission Oil Filler Tube


Using a 6 mm socket hexagon wrench, remove the No. 1 transmission oil filler tube from the oil pan and drain the continuously variable transaxle fluid.


Hide 35106L 5.REMOVE TRANSAXLE OIL PAN SUB-ASSEMBLY

a.
C200350

Remove the 19 bolts and oil pan from the continuously variable transaxle assembly.

NOTICE:

Some fluid will remain in the oil pan. To prevent the fluid from spilling, place a container under the oil pan, and then carefully remove all the pan bolts and oil pan assembly.



b.

Remove the gasket from the oil pan.


c.
C103347C01
2.766,0.802 2.934,0.97 0.169,0.168 10 *1 2.0,1.061 2.727,0.911 2.727,0.911 1.843,1.582 false 1.525,1.518 2.727,0.911 false
*1 Magnet


Remove the 3 magnets from the oil pan.

NOTICE:
·

Clean the oil pan and remove any metal particles, sludge, etc.

·

Clean off any metal particles that adhere to the magnets.