*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Measure the battery voltage.
11 to 14 V (Ignition switch off)
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
If the battery voltage is below 11 V, recharge or replace the battery and initialize* the integrated current value using the GTS.
*: Use the GTS to perform Integrated Current Value Initialization.
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 3ZR-FAE)>REGISTRATION
If the Data List item "Integrated Current" is 0 or higher, it is not necessary to perform initialization.
Check the fuses and relays.
Check the connector connections and terminals to make sure that there are no abnormalities such as loose connections, deformation, etc.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 3ZR-FAE)>DTC CHECK / CLEAR
Check for freeze frame data.
Record or print DTCs and freeze frame data if necessary.
Clear the DTCs and freeze frame data.
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 3ZR-FAE)>DTC CHECK / CLEAR
Recheck for DTCs.
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 3ZR-FAE)>DTC CHECK / CLEAR
If any DTCs for the CAN communication system are output, troubleshoot those DTCs first.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Refer to Problem Symptoms Table.
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 3ZR-FAE)>PROBLEM SYMPTOMS TABLE
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Data List / Active Test
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 3ZR-FAE)>DATA LIST / ACTIVE TEST
Terminals of ECU
Click hereEngine / Hybrid System>STOP AND START>STOP AND START SYSTEM(for 3ZR-FAE)>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Warm up the engine.
Turn the air conditioning system off.
Drive the vehicle for 5 to 40 minutes.
When performing Confirmation Driving Pattern, obey all speed limits and traffic laws.
Stop the vehicle and confirm that the engine is stopped by stop and start control when all of the following conditions are met:
Steering wheel centered
for CVT:
- Shift lever in D
- Brake pedal depressed
for Manual Transaxle:
Shift lever to neutral and release the clutch pedal.
Stop and start indicator light illuminated
If the engine is not stopped by stop and start control, air fuel ratio learning and idle speed learning are necessary. Allow the engine to idle for 3 minutes and check that the engine idle speed is within 50 rpm of the target idle speed.
for CVT:
Move the shift lever to P or N and confirm that the engine starts.
for Manual Transaxle:
Depress the clutch pedal and check that the engine restarts.
| Proceed to |
|---|
| NEXT |
NEXT