1.INSPECT INTAKE SYSTEM
Perform "Inspection After Repair" after repairing air leaks in the intake system.
for K111, K111F:
Click hereEngine / Hybrid System>3ZR-FE ENGINE CONTROL>SFI SYSTEM(for K111, K111F)>INITIALIZATION
except K111, K111F:
Click hereEngine / Hybrid System>3ZR-FE ENGINE CONTROL>SFI SYSTEM(except K111, K111F)>INITIALIZATION
Check that there is no air suction at the points shown in the illustration.
| *A | for LHD | - | - |
| *A | for RHD | - | - |
2.INSPECT INTAKE AIR CONTROL VALVE
Connect the GTS to the DLC3.
Start the engine and turn the GTS on.
Warm up the engine.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the VSV for Intake Control.
| Tester Display |
|---|
| Activate the VSV for Intake Control |
When "ACIS VSV" is turned on, check that the actuator rod operates.
If the operation is not as specified, inspect the intake air control valve and vacuum hose.
Click hereEngine / Hybrid System>3ZR-FE INTAKE / EXHAUST>INTAKE MANIFOLD>INSPECTION
When "ACIS VSV" is turned off, check that the actuator rod returns to its original position.
If the operation is not as specified, inspect the intake air control valve and vacuum hose.
Click hereEngine / Hybrid System>3ZR-FE INTAKE / EXHAUST>INTAKE MANIFOLD>INSPECTION