Home › Engine / Hybrid System › 2WW FUEL › FUEL PRESSURE SENSOR › from 2015.10
RM3090E _51 Engine / Hybrid System _044374 2WW FUEL _0221824 FUEL PRESSURE SENSOR A

2WW FUEL  FUEL PRESSURE SENSOR  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After the engine has stopped, wait at least 1 minute before releasing the high pressure lines.

·

When working on the fuel circuit, protect the generator assembly against contamination. Cover the generator assembly with suitable materials. Failure to comply with this procedure may result in a generator assembly malfunction.

·
A316354N01
2.656,0.188 0.958,0.188 0.958,0.188 0.958,0.417 false 2.375,0.406 2.375,0.188 false 2.74,0.104 3.198,0.302 0.458,0.198 10 false SST

After disconnecting the pressure line, it is absolutely essential to seal the injector assemblies and the common rail assembly with SST.

SST:

PZ4TB-04941-79




Hide 23810A 2.REMOVE COMMON RAIL ASSEMBLY

Hide 89458A 3.REMOVE FUEL PRESSURE SENSOR

a.
A316318

Remove the fuel pressure sensor.


b.

Cover the connector of the fuel pressure sensor and remove any thread-locking sealant from the threads with a suitable cleaning agent. Clean the threads and sealing surface on the common rail assembly and seal with SST.