Home › Engine / Hybrid System › 2WW FUEL › COMMON RAIL › from 2015.10
RM3090E _51 Engine / Hybrid System _044374 2WW FUEL _0221822 COMMON RAIL A

2WW FUEL  COMMON RAIL  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:
·

After the engine has stopped, wait at least 1 minute before releasing the high pressure lines.

·

When working on the fuel circuit, protect the generator assembly against contamination. Cover the generator assembly with suitable materials. Failure to comply with this procedure may result in a generator assembly malfunction.

·
A316354N01
2.656,0.188 0.958,0.188 0.958,0.188 0.958,0.417 false 2.375,0.406 2.375,0.188 false 2.74,0.104 3.198,0.302 0.458,0.198 10 false SST

After disconnecting the pressure line, it is absolutely essential to seal the injector assemblies and the common rail assembly with SST.

SST:

PZ4TB-04941-79




Hide 3.REMOVE INJECTION PIPE SUB-ASSEMBLY

Hide 4.REMOVE FUEL INLET PIPE SUB-ASSEMBLY

a.
A316271C01
0.51,2.229 0.677,2.229 0.677,2.229 0.865,1.875 true 0.927,2.698 0.927,2.51 0.927,2.51 1.302,2.313 true 1.563,1.198 1.781,0.844 1.781,0.844 1.969,0.844 false 0.323,2.146 0.521,2.333 0.198,0.188 10 true *1 0.854,2.729 1.135,2.917 0.281,0.188 10 true *2 2.031,0.771 2.49,0.969 0.458,0.198 10 false SST
*1 Rubber Grommet
*2 Rubber Mount


Using SST, loosen the union nut at the common rail assembly end of the fuel inlet pipe sub-assembly.

SST:

PZ4TB-04959-10


NOTICE:

Reset SST in a timely manner to prevent bending of pressure lines.



b.

Using SST, loosen the union nut at the fuel supply pump assembly end of the fuel inlet pipe sub-assembly.

SST:

PZ4TB-04959-10


NOTICE:

Reset SST in a timely manner to prevent bending of pressure lines.



c.

Remove the fuel inlet pipe sub-assembly from the rubber grommet and rubber mount.


Hide 23810A 5.REMOVE COMMON RAIL ASSEMBLY

a.
A316282

Disconnect the fuel pressure sensor connector.


b.
A340054

Disconnect the pressure discharge valve assembly connector.


c.
A340055C01
0.656,0.24 0.969,0.396 0.313,0.156 10 false *a
*a Push


Push at the location shown in the illustration and disconnect the fuel return tube.


d.
A316281

Using an E10 "TORX" socket wrench, remove the 4 bolts and 2 common rail assembly brackets.


e.

Remove the common rail assembly from the cylinder head cover sub-assembly.


Hide 89458A 6.REMOVE FUEL PRESSURE SENSOR

Hide 23990 7.REMOVE PRESSURE DISCHARGE VALVE ASSEMBLY