This circuit includes the parking brake switch assembly and radio and display receiver assembly.
Check that the wire harness is properly installed and does not have any sharp bends, pinching or loose connections.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Display the "Vehicle Signal Check Mode" screen.
Check that the display changes between ON and OFF according to the parking brake operation.
| Parking Brake Condition | Display |
|---|---|
| Applied | ON |
| Released | OFF |
This display is updated once per second. As a result, it is normal for the display to lag behind the actual parking brake operation.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the G143 radio and display receiver assembly connector.
Disconnect the G37 parking brake switch assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G143-15 (PKB) - G37-1 | Always | Below 1 Ω |
| G143-15 (PKB) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the parking brake switch assembly.
Inspect the parking brake switch assembly.
Click hereBrake>PARKING BRAKE>PARKING BRAKE SWITCH>INSPECTION
| Proceed to |
|---|
| OK |
| NG |
OK
NG